Blendtec EXPRESS Istruzioni per gli Interventi Scaricare il pdf (Pagina 9)

Page 7

SECTION 4: INSTALLATION

4.1 Xpress Installation

1. Place blender on a at, clean, dry surface.

2. Make sure plug outlet is available within four feet of the motor base.

3. Plug the unit into a 220/240 volt receptacle with 7.5 amp protection.

Make sure switch is turned off before plugging in. Failure to use a

dedicated line may result in damage to the blender. Lack of adequate

power causes the motor to overheat (which shortens the life of the

blender electronics.) Operating the blender in this manner will void the

warranty.

4. Ensure that the blender vents are unobstructed to allow for proper

cooling during use.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Nessun commento

Blendtec EXPRESS Istruzioni per gli Interventi Pagina 9